| 1 |
 |
Remove plastic backing from clear film. |
| 2 |
 |
Place motif on garment or textile with adhesive side down. Cover with PTFE Non-Stick
sheet (available from Kandi Corp) |
| 3 |
 |
You are now ready to heat transfer. Use a dry iron, no steam. Use Cotton setting -
temperature 300 - 340 F. Iron for 10-20 seconds. |
| 4 |
 |
Insert the PTFE Non-Stick sheet inside the garment and iron on the back of the garment
approximately 30 seconds. |
| 5 |
 |
Allow motif to cool for approximately 10 seconds before removing clear protective film. |
| 6 |
 |
For a permanent seal, reapply PTFE Non-Stick sheet over motif and iron for another 20
seconds. |
| 7 |
 |
Your transfer should now be permanently sealed to the garment or fabric and is
washer/dryer safe or may be dry-cleaned. |
| |
Metallic Nailheads & Crystal stones will NOT adhere to the following materials:
Leather, Imitation Leather or Oil-Treated Fabrics, Waterproof Coated Fabrics (Teflon, Silicone, etc.), Rubberized Materials |
Fine Materials:
e.g. Silk, Polysilk, Lycra
Temperature: 325-340 F
Pressure: light (25-30 lb)
Time: 7 - 10 seconds
Remove clear film
Reapply heat for additional 7-10 seconds |
Heavy Materials:
e.g. Jersey, Fleece, Denim
Temperature: 350F
Pressure: light to medium (30-40 lb)
Time: 10 -12 seconds
Remove clear film.
Reapply heat for additional 10-12 seconds |
When working with a delicate fabric
insert protective pad inside garment.
If working with a covering cloth please be sure to apply cloth after removing clear film before reapplying heat for second time. |
Pre-test dark colors or non-reactive dyed fabrics
for color change from heat.
|
|
